PLEASE READ THE WHOLE DESCRIPTION AND POLICY TERMS BEFORE PURCHASE. 

Our items are custom made to order, therefore NO RETURNS or exchanges will be accepted.

FINISHES;

MATTE FINISH: This will print from matte to satin depending on the ink coverage and the color. The darker the print pattern the glossier it will look. If you are unsure, please buy one and try it out.

GLOSS FINISH: This will have a wet look with a rich gloss look.

PLEASE CONTACT ME FOR A CUSTOM SIZE OR IF YOU HAVE YOUR OWN IMAGE TO BE PRINTED.

If you are unsure if magnet will stick to your appliance please choose " Magnet Sample" in the menu for a small 2x2 unprinted sample.

Choose between a Magnet or Decal vinyl sticker cover for dishwasher or similar appliances, waterproof self-adhesive. This is an inexpensive way to spruce up your kitchen with minimal effort and cost. For magnet orders please check your appliance surface with a magnet prior to order to make sure it is sticking.

It comes in a few different sizes, but we can customize at no cost to fit your appliance, if you contact us first. Choose the type and size from the menu. The magnet and decals can be easily trimmed with scissors, Exacto knife or similar box cutter knife.

We will customize your order at no cost, contact us first before placing order.

All of our magnets and decal covers are print and cut to order and therefore NOT RETURNABLE. Please make sure to ask any questions regarding this item prior to ordering.

All magnets and decals are shipped rolled in a tube.

CLEANING:

Gentle cleaning the graphics with soapy water and a soft cloth. No hard scrubbing with abrasive sponges or harsh chemicals.

INSTALLATION:

FOR VINYL DECALS

Measure and trim the decal if necessary before removing the back paper to match the size of the appliance.

Make sure all surfaces are smooth and clean.

Prior to installation wipe all surfaces with alcohol and let dry.

PRE-CAUTIONS BEFORE YOU START.

Recommended room and installation surface temperature to be between 65°F and 80°F to reduce stretching or other un-desired effects.

Do not install your vinyl decal in direct sunlight.

Do not install graphics outdoors if windy. Blown dirt, dust or other contaminates can interfere with the bonding of the graphic adhesive to the vehicle during installation.

This method is not recommended for surfaces that can be damaged by being wet. Please use your judgement when considering the wet installation method.

Do not store your vinyl decal in direct sunlight.

Do not substitute wet application mix for alcohol to apply, it will destroy the adhesive.

Do not touch the adhesive backing, oils from your skin will prevent sticking.

MATERIALS NEEDED

Spray Bottle.

Plastic Squeegee or a credit card wrapped in a piece of cloth to avoid scratches on the graphic.

Application Fluid 5% dishwasher soap to 95% water

Utility Knife

Scissors,

Rubbing Alcohol

Tack Rag other Lint Free Towel

Roll of Paper Towels

INSTALLATION

Wet Installation, recommended for large vinyl decals

Spray the surface where the decal will be applied generously with the application fluid.

Peel the backing from the decal exposing the adhesive. Spray the back of the vinyl as you peel it back.

Place the decal on the surface ensuring no part of the decal touches a try spot! Maneuver the decal into position (decal should float on the surface because both decal and the surfaces should be wet). Once in position apply slight pressure up and down in the middle section so the decal sticks and not move from the desired position. Using a squeegee or an old credit card wrapped in cloth, start from the middle working towards the edge with mild pressure. Work the water bubbles out towards the edge holding the vinyl up from the surface and making sure no water or bubbles are trapped behind.

FOR MAGNET

Measure and trim if necessary.

Apply

Periodically remove magnet and make sure water does not get trapped under the magnet that can cause rust in the long term.

Enjoy.